10 Ways to Reduce Static Build Up in Blast and Vacuum Hoses


A few simple steps can be taken to reduce and dissipate the static electricity for a safer Blast System.

Static electricity is more dangerous than a simple shock to your blaster or painter. Certain densities of dust are as explosive as solvent fumes. A spark in either environment can be a fatal disaster.

Static electricity is a concern that we find is common in the dry winter months, although it is prevalent at any time of the year.

blast and vacuum hose static
Static Danger
  1. Ensure the nozzle washer is in place.

    No washer fitted' is the most common cause of shock. There are several types and manufacturers of Nozzle washers which have varying conductivity ratings.

  2. Use a conductive concealer to seal off gaps between blast hose & the coupling.

    This assists in a tight bond and completes the conductivity path. It is important to use silicone to seal off gaps between blast hose & the coupling to assist in a tight bond and conductivity path.

  3. Use a quality blast hose which has a high carbon content.

    This ensures conductivity from the inside tube to the outside cover, which guarantees a continuous grounding path wherever the hose rests on the ground.

  4. Ground your large equipment using an earthing stake.

    Especially if your blasting equipment is mounted on a trailer with tyres or is on rubber mats. You will always have static issues unless you earth the units. If you're blasting equipment is a mounted on a trailer with tyres or is on rubber mats you will always have static issue unless you ground the workpiece using an earthing stake.

  5. Use an earthing stake at the Blast Pot.

    This also dissipates the charge from the blast hose and nozzle.

  6. Wind a bare earth wire around the entire blast system.

    This is another earthing option - include the nozzle, blast hose and blast pot then connect to a good earthing stake to dissipate the static electricity.

  7. Ensure good connectivity between all equipment around tank farms and petroleum tanks especially when working in flammable areas.

    It may help to separately earth the nozzle and hose. Some recommend that the blast nozzle and the blast hose have separate grounding wires to dissipate the static electricity. In these areas it is essential that there is connectivity between the blast nozzle, blast pot and tank to avoid any sparks.

  8. Use an aluminum nozzle holder.

    When using an aluminum nozzle some blasters have found they get less static if they switch from a plastic to an aluminum nozzle holder.

  9. Check for obvious damage to blast hose.

    If a blast hose is damaged by a forklift tire or similar this may break the special copper wire conduit, which many good quality hoses contain, reducing the conductivity of the hose.

  10. Wear conductive type footwear.

    All blasters should wear conductive type footwear when using any well earthed blasting system.‚Äč


These 10 tips will help reduce static build up for a safer work space.