IMAGES & VIDEO

Graco Mark HP XT Electric Airless Sprayers

SKU: P-MARKHPXT

The Graco Mark HP XT Electric Airless Sprayers are high pressure electric units designed for spraying hard to atomize coatings without relying on gas power. Built with XT Motor and AMPLIFI Technology, they deliver up to 6750 PSI from standard 120V or 230V outlets while maintaining consistent output under load.

Electric high pressure airless sprayer delivering up to 6750 PSI
Sprays 100 percent solids, epoxy, silicone, vapor barriers, polyurethane and protective coatings
XT Motor with dual voltage 120V or 230V flexibility
Endurance Pump with ProConnect lower for fast changeouts
Maximum tip size 0.041 inch, up to 1.5 GPM flow rate
SKU options: 18H410, 18H411, 2015642

Graco Mark HP XT Electric Airless Sprayers

SKU: P-MARKHPXT

Graco Mark HP XT Electric Airless Sprayers

Sku: P-MARKHPXT

The Graco Mark HP XT Electric Airless Sprayers are engineered for contractors who need extreme pressure capability in an electric platform. With a maximum output of 6750 PSI and 1.5 GPM flow, these units are built for 100 percent solids coatings, epoxy, silicone roof coatings, vapor barriers, intumescent materials, and other high build protective systems. They provide the pressure and flow typically associated with gas sprayers, while operating from standard 120V or 230V power sources.

The integrated XT Motor uses a high torque, low RPM design to maintain consistent pressure under heavy load. AMPLIFI Technology increases usable power from the same outlet and allows selectable amperage settings to help reduce nuisance breaker trips on common circuits. This makes the Mark HP XT platform suitable for indoor work, occupied facilities, and projects where gas engines are restricted.

Each unit features a direct immersion Endurance Pump designed for demanding, high viscosity materials. ProConnect allows crews to swap the lower pump assembly in minutes to minimize downtime. Rapid Response pressure control with digital display provides fast, accurate pressure adjustments for consistent atomization across a range of coatings. TurboClean flush capability and WatchDog protection help speed up cleaning and reduce the risk of pump damage.

Available configurations include:

18H410, Mark HP XT Complete
18H411, Mark HP XT Big 150
2015642, Mark HP XT Big 150 with 25 gallon hopper
Maximum pressure: 6750 PSI, 465 bar
Maximum flow rate: 1.5 GPM, 5.71 LPM
Maximum tip size: 0.041 inch
Voltage range: 120V or 230V flex voltage operation
Supported materials: 100 percent solids, epoxy, silicone, vapor barriers, polyurethane, protective coatings
Endurance direct immersion pump designed for high solids materials
ProConnect lower for fast on site pump change
Digital pressure display with Rapid Response control
TurboClean flush system for faster cleaning
WatchDog protection system to help prevent pump damage